Rigger and Signal Person Training 4/18 HR

RIGGER AND SIGNAL PERSON TRAINING
Thursday, April 18, 2024 | 4:00PM – 7:00PM
This training is for individuals who work under the supervision of a competent person and on a routine basis perform rigging work engaged in lifting loads other than rigging for special lifts, or the erection, dismantling, jumping or reconfiguring of cranes or all of these. This person is also trained to communicate guidance and direction to a crane operator in lifting, hoisting, moving, or releasing a load.

Upon completion of this course, employees shall be able to demonstrate specific knowledge of the following:
• Hand, voice and radio communications
• Proficiency in hand and verbal signals, including the standard method for hand signals as required by ASME B30.3-2004, ASME B30.5-2007 and ASME B30.6-2003
• Rigging hardware, including: Hooks and similar attaching devices; shackles, clips, and clamps; and taglines
• Synthetic/wire rope slings
• Common load configurations and positioning
• Personal fall protection methods
• Emergency procedures
• Hazards and restrictions associated with working adjacent to overhead electric lines and equipment.

Attendees should provide their own rigging equipment. Doing so will provide the opportunity to learn how to properly use and inspect their own equipment.

LOCATION **PLEASE NOTE OUR NEW ADDRESS**
ABC-VA Hampton Roads Training Facility
530 Independence Parkway, #500, Chesapeake, VA 23320
*Student parking + entrance is located in the back of the building.*

COST
Member: $110
Non-Member: $145

COURSE CONTACT
Jamie Carrow